A full service goes beyond routine checks. Our engineers strip the drone down completely, clean every component, assess wear against manufacturer tolerances and replace anything that falls short. The drone is then recalibrated from scratch and performance-tested in flight before being returned to you with a detailed service report and updated log.
- Complete disassembly, ultrasonic cleaning and reassembly by certified engineers
- All components inspected against manufacturer wear tolerances
- Gimbal realignment and camera sensor deep cleaning
- Full battery cycle testing and degraded cell replacement
- Flight controller recalibration, compass and IMU reset
- Performance test flight before drone is returned to you
- Detailed service report and updated maintenance record
We service all major brands including DJI, Autel Robotics, Parrot, Yuneec, senseFly and custom-built platforms. Only genuine or OEM-spec parts are used.
Scope of Work
What's Covered in a Full Service
Every full service covers four core disciplines: mechanical, electrical, software and structural. so no system is left uninspected.
- Motor bearing inspection & replacement
- Propeller balance and replacement
- Frame joint and arm torque check
- Landing gear and damper inspection
- ESC load test and heat assessment
- Battery cell balance and capacity test
- Wiring harness and connector check
- Signal board and port inspection
- Full firmware update to latest stable
- IMU and compass recalibration
- Gimbal motor and encoder calibration
- Controller link and failsafe verification
- Airframe crack and stress inspection
- Waterproofing and IP seal check
- Vibration damper condition assessment
- Overall weight and balance verification
How It Works
The Servicing Process
Book & Drop-off
Schedule your service slot online or by phone. Bring your drone to our campus workshop. No shipping required.
Full Diagnostic Assessment
Before any work begins, we run a complete diagnostic scan and document the drone's condition, flight hours and all known issues.
Strip & Deep Clean
The drone is fully disassembled. Each component is cleaned and inspected individually to manufacturer tolerances.
Repair & Replace
All worn, damaged or degraded components are replaced with genuine parts. Nothing is reinstalled unless it passes inspection.
Reassembly & Calibration
The drone is reassembled precisely. All sensors, compass, IMU, gimbal and controller links are recalibrated from scratch.
Flight Test & Sign-off
A performance test flight confirms all systems are operating correctly. A signed service report is issued before return.
Time for a full service?
Book your drone in today. No commitment until you approve the quote. We respond within one business day.